MOULD - DEVELOPMENT

content_werkzeug

In addition to the feedstock, the mould plays a crucial role in ceramic injection moulding. The construction of the mould differs in important ways from that used in plastic injection moulding.


The part shrinks to its final size during sintering. This dimensional change must be incorporated into the mould design. The precision of the part depends directly on the precision of the mould. Parts that are close to their final form and require little or no finishing can only be produced with high precision mould inserts, preferably made of hard metal. With INMATEC Technologies as your competent partner you can benefit from our wealth of experience right from the initial phase of designing the part.

INMATEC Technologies will develop the mould together with you from prototype construction through to the optimised production mould.

© INMATEC Technologies GmbH 2008-2017